In most construction site tents are prepared for fabrication of bracket and inspection is conducted on the accessories before the application techniques and further modification of the process design. And such processes may includes the following i) welding, ii)grinding,iii)brushing and iv) painting,which should be coated and performed to suite the specification . Moreso a grinding wheel will not be mistaken for a cutting wheel despite the specification that exist between them,because where adequate training is not provided in a construction site,anomaly on the activity is possible ..An effective gas leakage test is also conducted by using a calibrated explosive meter instrument, including an environmental sanitation to avoid unforeseen disaster .If a welding or grinding work is to be carried out, each section of any of the area to be grinded or welded should be fully accommodated in the the tent.And some fire extinguishers are located within the grinding zones. It is imperative to fit pump suction and discharge spools to the expected recommendation. And the alignment of the adjoining flange to flange of the gearbox and pump be obtained as data derived from the measurement will be in the order of the expected priority of concentricity or results.
No comments:
Post a Comment